WARNING: Show
1. Disconnect the negative battery cable.. 2. Remove the front under cover No.2.. 3. Remove the generator drive belt.. 4. Remove the A/C compressor with the cooler hose still connected and secure it using wire or rope so that it is out of the way.. 5. Remove in the order indicated in the table. 6. Install in the reverse order of removal.
Generator Removal Note 1. Fully loosen the generator lower bolt and pull it outward until it contacts the body frame. NOTE:
2. Remove the generator upper bolt. 3. Remove the generator together with the lower bolt from the engine. 4. Remove the generator from above the engine compartment.
Generator Installation Note 1. To facilitate the installation of the generator to the engine, grasp the spacer in the bolt installation hole using pliers and push it down to the nut side.
2. Temporarily install the generator to the engine with the bolt C.
3. Align the generator fixing hole with the engine side hole, then temporarily tighten the generator installation bolt B. 4. Securely tighten the generator installation bolts in the order of B, C. Drive Belt Auto Tensioner Installation Note CAUTION:
1. Install the drive belt auto tensioner to the engine. CAUTION:
2. Insert the wrench into the cast hexagon on the drive belt auto tensioner, move the drive belt auto tensioner up and down at full-stroke three times to bleed the air.
NOTE:
Generator Inspection [Skyactiv G 2.0]CAUTION: Do not apply direct battery positive voltage to generator terminal D, otherwise it could cause damage to the internal parts (power transistor) of the generator. Charging syst ... Generator [Skyactiv G 2.0]Purpose, Function The generator operates by obtaining drive force from the engine via the drive belt and generates the required electricity for electronic devices. Construction ... Other materials:Fuel Injector Inspection Passenger Side Air Bag Module [Standard Deployment Control System] Rear Sash Molding Installation © 2016-2022
Copyright www.mcx5.org How much does it cost to replace an alternator in a Mazda CXMazda CX-5 Alternator Replacement Cost Estimate. The average cost for a Mazda CX-5 alternator replacement is between $576 and $675. Labor costs are estimated between $161 and $203 while parts are priced between $415 and $472.
How long does an alternator last on a Mazda CXAn alternator can generally last for about 150,000 miles or 7-8 years before needing replacement.
Does Mazda CXYour Mazda CX-5 will be happy to know that the search for the right Alternator products you've been looking for is over! Advance Auto Parts has 5 different Alternator for your vehicle, ready for shipping or in-store pick up. The best part is, our Mazda CX-5 Alternator products start from as little as $252.99.
How much does it cost to replace a Mazda alternator?It takes about 2 hours for an alternator replacement — about as long as a driveline repair and a little quicker than a clutch repair. The estimated price for parts (including a replacement belt) can range around $290 – $600. And depending on where you get the auto service, labor can cost between $85 to $800.
|