✔️ You can program new Key Fob or re-program previously
programmed on this vehicle Key Fob. This guide applies to the following cars: If the vehicle
is equipped with Keyless Enter-N-Go, remove the Engine START/STOP button. Then insert the new Key Fob in the ignition and turn to the RUN position.Learn how to program new Key Fob for 2008-2016 Chrysler Town&Country, 2008-2020 Dodge Grand Caravan and other related minivans using Appcar software.
❌ Programming a used Key Fob, previously programmed for another vehicle, requires unlocking by erasing the internal key memory with a special locksmith tool.
1️⃣ Insert the new Key Fob in the ignition and turn to the RUN position.
EVIC will display message: ‘Key Not Programmed’.
You can find it in Diagnostic -> WCM -> Routines. The PIN code will be needed when programming the new Key Fob.
👉 How to read PIN Code
3️⃣ Run ‘Program Ignition Keys or Key FOBs’ routineOn the first step you will see the number of currently programmed keys. Usually can be a maximum of 8.
In the second step, you have to enter the 4-digit PIN code.
Then the ignition module will start the Key Fob programming procedure. It may take several seconds.
After a while you should see the programming result and the number of currently programmed key fobs – one more than before 👌
and the programmed key supports this function (cheap replacements usually do not support it) – 👉 PEM Replace Routine should be run. You can find it in Diagnostic -> PEM -> Routines.
⚠️ Common causes when the ignition module is unable to program the key:– wrong key fob type – similar looking key fobs are not interchangeable,
– the key fob was already programmed to another vehicle,
– the maximum number of programmed
keys has been exceeded,
– too low or too high key fob battery voltage – should be around 3.3 Volts